PIC18F4520 Specs
PIC18F4520 is a great PIC MCU to start working with. It has many features and easily affordable. This PIC is re-programmable many times because it has flash memory and programming can be done using IC-Prog program. Following are PIC18F4520 specifications from Microchip website.
| Parameter Name |
Value |
| Program Memory Type |
Flash |
| Program Memory (KB) |
32 |
| CPU Speed (MIPS) |
10 |
| RAM Bytes |
1,536 |
| Data EEPROM (bytes) |
256 |
| Digital Communication Peripherals |
1-A/E/USART, 1-MSSP(SPI/I2C) |
| Capture/Compare/PWM Peripherals |
1 CCP, 1 ECCP |
| Timers |
1 x 8-bit, 3 x 16-bit |
| ADC |
13 ch, 10-bit |
| Comparators |
2 |
| Temperature Range (C) |
-40 to 125 |
| Operating Voltage Range (V) |
2 to 5.5 |
| Pin Count |
40 |
Features |
CPU - Up to 10 MIPS performance
- C compiler optimized RISC architecture
- 8 x 8 Single Cycle Hardware Multiply
System - Internal oscillator support - 31 kHz to 8 MHz, up to 32 MHz with 4X PLL
- Fail-Safe Clock Monitor – allows safe shutdown if clock fails
- Watchdog Timer with separate RC oscillator
- Wide operating Voltage range; 2.0V to 5.5V
nanoWatt Power Managed Modes - Run, Idle and Sleep modes
- Idle mode currents down to 5.8uA typical
- Sleep mode currents down to 0.1uA typical
Analog Features - 10-bit ADC, 13 channels, 100K samples per second
- Programmable Low Voltage Detection Module
- Programmable Brown-out Reset module
- Two Analog comparators with input multiplexing
Peripherals - Master Synchronous Serial Port supports SPI ™ and I2C™ Master and Slave Mode
- EUSART module including LIN bus support
- Four Timer Modules
- Up to 5 PWM outputs
- Up to 2 Capture / Compare
|
|
